From: Scott Morris (swm@emanon.com)
Date: Fri Mar 14 2003 - 10:16:24 GMT-3
You are correct in your configuration. Now, you DO need to configure
the other side to receive the rspan. :)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
cebuano
Sent: Thursday, March 13, 2003 11:56 PM
To: ccielab@groupstudy.com
Subject: Need help on RSPAN configuration
Hi all.
I'm not sure I'm following the example on the Configuration Guide for
RSPAN. Here's my setup. 3550a is VTP server, 3550b is client mode. 3550a
ports 23/24 <-- FEC/ISL --> 3550b ports 23/24. 3550a port 1 <-- ISL
Trunk --> R1 port 2 is configured for R2 in VLAN 20. Port 3 is
configured for R5 in VLAN 10. 3550b port 14 has a PC in VLAN 192.
I need to monitor R1,2,5 in 3550a, the destination is PC in 3550b. My
config is as follows (I'm sure this is wrong).
3550a#
int vlan 200 ------ VLAN created for RSPAN purposes only
monitor session 1 source int fa0/1 tx
monitor session 1 source int fa0/2 rx
monitor session 1 source int fa0/3 rx
monitor session 1 destination remote vlan 200 reflector-port fa0/23
Please correct my confusion on this topic.
Thanks.
Elmer
This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:39 GMT-3