From: cebuano (cebu2ccie@cox.net)
Date: Fri Mar 14 2003 - 01:56:06 GMT-3
Hi all.
I'm not sure I'm following the example on the Configuration Guide for
RSPAN.
Here's my setup.
3550a is VTP server, 3550b is client mode.
3550a ports 23/24 <-- FEC/ISL --> 3550b ports 23/24.
3550a port 1 <-- ISL Trunk --> R1
port 2 is configured for R2 in VLAN 20.
Port 3 is configured for R5 in VLAN 10.
3550b port 14 has a PC in VLAN 192.
I need to monitor R1,2,5 in 3550a, the destination is PC in 3550b.
My config is as follows (I'm sure this is wrong).
3550a#
int vlan 200 ------ VLAN created for RSPAN purposes only
monitor session 1 source int fa0/1 tx
monitor session 1 source int fa0/2 rx
monitor session 1 source int fa0/3 rx
monitor session 1 destination remote vlan 200 reflector-port fa0/23
Please correct my confusion on this topic.
Thanks.
Elmer
This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:39 GMT-3