Re: Advertising default route in OSPF to some routers, not all

From: Jun Qian (johnjunqian@yahoo.com)
Date: Mon Mar 10 2003 - 22:33:22 GMT-3

• Next message: Jun Qian: "Re: Qs about Frame Relay end-to-end keepalive"
• Previous message: Mustafa M Bayramov: "RE: Async dynamic routing not work"
• Maybe in reply to: Tran Tien Phong: "Advertising default route in OSPF to some routers, not all"
• Next in thread: Jack DeLaGarza: "Re: Advertising default route in OSPF to some routers, not all"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi, Tran Tien Phong

I think that the "default-information originate always
" control router create default route.
Could you try to use "distribute-list xxx out s0" on
R2.

Jun

--- Tran Tien Phong <PhongTT2@FPT.COM.VN> wrote:
> Hi friend,
>
> Topology:
>
> R1 (e0)---------------(e0) R2
> (s0)------------------(s0) R3
>
> R1, R2 and R3 all run OSPF in area 0
>
> I would like to make R2 advertise a default route
> only to R1, not R3, I
> configured as below:
>
> R2:
>
> router ospf 100
> network A.A.A.A B.B.B.B area 0
> default-information originate always route-map
> onlyR1
>
> route-map onlyR1 pemit 10
> match interface e0
>
> Did not work ! Both R1 and R3 have the default route
> in its routing
> table.
>
> Any ideas?
> TIA
> Phong

• Next message: Jun Qian: "Re: Qs about Frame Relay end-to-end keepalive"
• Previous message: Mustafa M Bayramov: "RE: Async dynamic routing not work"
• Maybe in reply to: Tran Tien Phong: "Advertising default route in OSPF to some routers, not all"
• Next in thread: Jack DeLaGarza: "Re: Advertising default route in OSPF to some routers, not all"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:36 GMT-3