From: Mustafa M Bayramov (spyroot@azeronline.com)
Date: Mon Mar 10 2003 - 23:04:22 GMT-3
Use async default routing -- enable routing protocol on async interface
"async dynamic routing" -- enable remote user use /route command if the
"async mode" configure interactive.
Regards
Mustafa M Bayramov
CISSP
CCNP,CCDP,Cisco Security Specialist
Network engineer and security analyst
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Hoang Duc Phuong
Sent: Thursday, January 01, 1998 12:02 AM
To: ccielab@groupstudy.com
Subject: Async dynamic routing not work
I have configured a connection through AUX por, in the interface
Async I
have issued "Async dynamic routing" command. But when I debug routing
event
(rip. OSPF,...) the two routers not advertise through Async interface.
Have you encountered this problem before ?
Does the "Async dynamic routing" always work correctly ?
Thank you inadvance !
Hoang DUc Phuong
This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:36 GMT-3