RE: 2620 router problem, please help

From: Khalid Ameen (khalid_ameen@rayaintegration.com)
Date: Wed Mar 05 2003 - 10:29:01 GMT-3

confreg ---> enter
then you will be asked if you want to change your settings or not , type Y
till you come to the buad rate get it back to 9600

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of Hunt
Lee
Sent: Wednesday, March 05, 2003 1:47 PM
To: ccielab@groupstudy.com
Subject: 2620 router problem, please help

Does anyone out there knows how to set the config-register for Cisco 2620?

I was doing an IOS upgrade for new flash so I change the baud rate to 115200
with
the confreg command in BootROM mode.

Now, my upgrade is done but the problem is I don't know how to set it back
to the
normal standard 9600.

I tried that confreg command (in BootROM) as well as using config-register
0x2102...
the router looks it boots up fine, but near the end of the bootup, it shows
up a
bunch of garbles... and I can't use the router ;-(

rommon 2 > confreg 0x2102

You must reset or power cycle for new config to take effect
rommon 3 > reset

cisco 2620 (MPC860) processor (revision 0x101) with 59392K/6144K bytes of
memory.
Processor board ID JAD043206M9 (2514823060)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
1 FastEthernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
2 Voice FXS interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
X|<|[~`_|_vvXW;^[LvX+.WO[Lvim{LZ<,_L[,O6Zg;&Z_2>Xi9:]

Z9[LCa^2aL^?{

And if I rebooted my router and go back to BootROM mode, the baud rate has
changed
itself back somehow to 115200..

Is there a command to clear the config-register value to its default?

Thanks in advance,

Best Regards,
Hunt

http://mobile.yahoo.com.au - Yahoo! Mobile
- Exchange IMs with Messenger friends on your Telstra or Vodafone mobile
phone.

This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:32 GMT-3