From: Mike Williams (ccie2be@swbell.net)
Date: Wed Mar 05 2003 - 02:49:44 GMT-3
Here's how I read this:
input gain
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/
fvvfax_r/vrf_g.htm#1287413
output attenuation
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/
fvvfax_r/vrf_g.htm#1024291
The higher the dB value you give on the command, the more gain (boost)
or attenuation (reduction) is applied to the signal.
And they could work together.... "If the voice level is too high, you
can decrease the volume by either decreasing the input gain or
increasing the output attenuation."
HTH,
Mike W.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Tony H.
Sent: Tuesday, March 04, 2003 9:31 PM
To: Emad; CCIE LAB (E-mail)
Subject: Re: OT VoIP question
Not sure on this one but think this is how it works..
Under voice-port
output attentuation <positive value> if this is
higher, then the sound is fainter
input gain <negative value> if this is more negative,
then volume is higher
HTH
--- Emad <emad@zakq8.com> wrote:
> Dear all,
> Somebody asked me a question about a solution of
> VoIP of his own with very basic configurations which including only
> routing between calls but he faced that in one side the voice is weak
> to be heard and in the other one , the voice is loud more than
> enough to be heard , what is the problem exactly?
>
> Emad,
This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:32 GMT-3