From: bobdu11@cox.net
Date: Mon Mar 03 2003 - 10:22:40 GMT-3
Yes you can. I have used these modules on 3660's and 2621's and you can treat apply all layer 3 functionality to them....Bob
>
> From: Raj Bahad <raj.bahad@totalise.co.uk>
> Date: 2003/03/03 Mon AM 06:22:16 EST
> To: ccielab@groupstudy.com
> Subject: Cisco 3745 with NM-16ESW - Please help!
>
> Hi,
>
> I've scoured all the possible documentation I could get my hands on but am
> unable to find an answer to a specfic question. Unfortunately, I don't have
> this kit at hand to try it out! Also, because of the place I am currently
> working at, they don't have any long term relationships with any Cisco
> partners who may be able to test this scenario for me.
>
> I was hoping that someone on this list may have come across a similar
> situation and more importantly, have a definitive answer!
>
> I am considering install a 16 port EtherSwitch module (NM-16ESW) into the
> Cisco 3745 Router. I need to run NAT/HSRP/CB-WFQ on these interfaces and
> essentially need to know if the 16-port card supports full IP features. I've
> read on certain documents that this module does support IP routing
> (RIP/OSPF/EIGRP) and the obvious association of physical ports being assigned
> to VLAN interfaces to which i can assign layer 3 information. However,
> assigning IP addresses is not enough! I really need to know if i can treat
> these interfaces as 'normal' fasthethernet interfaces and not standard switch
> ports.
>
> For the people who have worked on 6509's it is easy to assign physical ports
> to VLANs and the assign ALL layer 3 commands to these logocal interfaces. Can
> the same be done with a Cisco 3745 router and NM-16ESW?
>
> Any input will be greatly appreciated.
>
> Thanks in advance,
>
> Raj
> CCIE #10256.
This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:31 GMT-3