From: Khalid A. Kaseb (khalid_ameen@rayaintegration.com)
Date: Wed Feb 26 2003 - 05:46:00 GMT-3
It depends on what process you advertise this loopback for example in
other words (if you advertise the loopback network in the ospf process
it will be reachable via any ospf router and wont be seen from isis
process until you redistribute connected under the ISIS process and vic
vesa) hope this help
Regards,
Khalid
-----Original Message-----
From: Hung, Sing-Yu [mailto:Sing-Yu.Hung@pccw.com]
Sent: Wednesday, February 26, 2003 3:11 AM
To: Khalid A. Kaseb; 'Pedro Eira'; ccielab@groupstudy.com
Subject: RE: ISIS and OSPF redist
Hi,
Is the "redistributed connected route-map subnets" under router
ISIS or OSPF?
Bradford Hung
Pacific Century CyberWorks
Tel: 288 33125
-----Original Message-----
From: Khalid A. Kaseb [mailto:khalid_ameen@rayaintegration.com]
Sent: Tuesday, February 25, 2003 11:04 PM
To: 'Pedro Eira'; ccielab@groupstudy.com
Subject: RE: ISIS and OSPF redist
Try using route-map subnets permit 10
Match interface loopback X
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Pedro Eira
Sent: Tuesday, February 25, 2003 3:42 PM
To: ccielab@groupstudy.com
Subject: RE: ISIS and OSPF redist
I first tried the isis commands on the interface, since that didn't
work
I did
# redistributed connected route-map subnets
- in OSPF, where the route-map had an acl for the ip on the loopback
address.
>From: "McCallum, Robert" >Reply-To: "McCallum, Robert" >To: "'Pedro
Eira'" , ccielab@groupstudy.com >Subject: RE: ISIS and OSPF redist
>Date:
Mon, 24 Feb 2003 21:26:04 -0000 > >what is the command you are using for
redistributing into isis and ospf. Have you got the keyword subnets on
the redistribution under the router ospf command? > > > -----Original
Message----- > > From: Pedro Eira [mailto:pdaeira@hotmail.com] > > Sent:
24 February 2003 15:35 > > To: ccielab@groupstudy.com > > Subject: ISIS
and OSPF redist > > > > > > Hello, > > > > I try to redistribute Lo 1 on
R2 which is in ISIS(everything > > is L2) into > > OSPF & Lo 0 on R2
which is in OSPF into ISIS, neither of > > those loopbacks > > get
redistributed into the other routing area. > > > > OSPF ISIS > > > >
R1---------R2---------R3 > > > > I've tried to also redistribute
connected, but have been > > unable to get it > > working. > > > > Any
ideas? > > > >
-------------------------------------------------------------- > >
---------- > > > > Add photos to your messages with MSN 8. Get 2 months
FREE*.
------------------------------------------------------------------------
MSN 8 helps ELIMINATE E-MAIL VIRUSES. Get 2 months FREE*.
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:36 GMT-3