Re: Cat3550's command

From: Mohamed Nizam (torontocisco@yahoo.ca)
Date: Wed Feb 26 2003 - 04:24:40 GMT-3

• Next message: CCIE FUN: "Re: cannot post , test ."
• Previous message: Donny MATEO: "Re: Multicast load splitting"
• Maybe in reply to: Tom Young: "Cat3550's command"
• Next in thread: Evgeny Tantsura: "Re: Cat3550's command"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

SW1(config-if)#switchport trunk encapsulation ?
  dot1q Interface uses only 802.1q trunking encapsulation when trunking
  isl Interface uses only ISL trunking encapsulation when trunking
  negotiate Device will negotiate trunking encapsulation with peer on
             interface

Is this what you are looking for ?

Thanks,

Mohamed Nizam

A Proud student of WinNET Harith.

----- Original Message -----
From: "Tom Young" <gitsyoung@yahoo.co.jp>
To: <ccielab@groupstudy.com>
Sent: Tuesday, February 25, 2003 4:54 AM
Subject: Cat3550's command

> Hello,group
>
> SOrry for a very simple question, what is the command for
> set the trunk mode ( auto ,desirabel, nonegotiate...)on a
> cat3550 switch, I use the ? make could find the hint in
> the switch.
>
> Thanks alot
>
> __________________________________________________
> Do You Yahoo!?
> Yahoo! BB is Broadband by Yahoo! http://bb.yahoo.co.jp/

• Next message: CCIE FUN: "Re: cannot post , test ."
• Previous message: Donny MATEO: "Re: Multicast load splitting"
• Maybe in reply to: Tom Young: "Cat3550's command"
• Next in thread: Evgeny Tantsura: "Re: Cat3550's command"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:35 GMT-3