From: Evgeny Tantsura (ivgen@castel.nl)
Date: Thu Feb 27 2003 - 21:28:43 GMT-3
SW3550(config-if)#switchport mode dynamic ?
auto Set trunking mode dynamic negotiation parameter to AUTO
desirable Set trunking mode dynamic negotiation parameter to DESIRABLE
> SW1(config-if)#switchport trunk encapsulation ?
> dot1q Interface uses only 802.1q trunking encapsulation when trunking
> isl Interface uses only ISL trunking encapsulation when trunking
> negotiate Device will negotiate trunking encapsulation with peer on
> interface
>
> Is this what you are looking for ?
>
> Thanks,
>
> Mohamed Nizam
>
> A Proud student of WinNET Harith.
>
>
>
>
> ----- Original Message -----
> From: "Tom Young" <gitsyoung@yahoo.co.jp>
> To: <ccielab@groupstudy.com>
> Sent: Tuesday, February 25, 2003 4:54 AM
> Subject: Cat3550's command
>
>
> > Hello,group
> >
> > SOrry for a very simple question, what is the command for
> > set the trunk mode ( auto ,desirabel, nonegotiate...)on a
> > cat3550 switch, I use the ? make could find the hint in
> > the switch.
> >
> > Thanks alot
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Yahoo! BB is Broadband by Yahoo! http://bb.yahoo.co.jp/
>
> ______________________________________________________________________
> Post your free ad now! http://personals.yahoo.ca
>
With kind regards/ met vriendelijke groeten,
------------------------------------------------
E. Tantsura
Network Developer
Essent Kabelcom N.V.
Dr.van Deenweg 84
8025BN Zwolle, The Netherlands
Tel: +31-(0)38-850-7642
Fax: +31-(0)38-850-7410
Mob: +31-(0)6-290-80458
------------------------------------------------
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:38 GMT-3