From: cdmurray@statestreet.com
Date: Sun Feb 23 2003 - 22:43:15 GMT-3
Here is an example of one of my policies so you can see the relationship
between the global and interface commands:
------------------------------------------------------------
route-map clear-df permit 10
match ip address 150
set ip df 0
!
interface FastEthernet0/0
ip policy route-map clear-df
!
-----------------------------------------------------------
Regards,
Christine Murray
cdmurray@statestreet.com
"Ong Boon Hui"
<ongbh@cet.st.com To: <ccielab@groupstudy.com>
.sg> cc:
Sent by: Subject: ip policy-map
nobody@groupstudy
.com
02/24/2003 12:32
AM
Please respond to
"Ong Boon Hui"
Hi,
I have problem enbling the ip policy-map command on my router.
R8(config-if)#ip policy?
policy
R8(config-if)#ip policy
% Incomplete command.
R8(config-if)#
Is this normal ?
My version is 12.1
3600 Software (C3640-JS-M), Version 12.1(5)YB4
Debarros
Confidentiality Notice:
**************************************************************************************************************************
The information contained in the email is intended for the confidential use
of the above-named recipient.
If the reader of this message is not the intended recipient or person
responsible for delivering it to the
intended recipient, you are hereby notified that you have received this
communication in error, and that
any review, dissemination, distribution, or copying of this communication
is strictly prohibited.
If you have received this in error, please notify the sender immediately
and destroy this message.
**************************************************************************************************************************
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:32 GMT-3