From: Jason Cash (cash2001@swbell.net)
Date: Sun Feb 16 2003 - 20:23:53 GMT-3
I was going to bump up the DRAM as that is the cheaper of the two. Can
I Have 64D with 8F and just do a net boot?
-----Original Message-----
From: kym blair [mailto:kymblair@hotmail.com]
Sent: Saturday, February 15, 2003 4:18 PM
To: cash2001@swbell.net
Subject: Re: Cisco 2600 Voice avail.
Jason,
You're going to need Enterprise+ for lots of topics. Bump your flash up
to
16MB and bump your DRAM at least to 48MB. Even BGP will give you
problems
if you have little memory. You'll have so much pain if you don't bump
it
up.
Sorry, don't know if you need Enterprise for NM-1V (or NM-2V) and
VIC-2FXS.
HTH, Kym
>From: "Jason Cash" <cash2001@swbell.net>
>Reply-To: "Jason Cash" <cash2001@swbell.net>
>To: <ccielab@groupstudy.com>
>Subject: Cisco 2600 Voice avail.
>Date: Fri, 14 Feb 2003 19:00:58 -0600
>
>I am thinking of buying FXS slots for 2 2600s that I have but have a
few
>questions:
>
>This is the mod I see on Ebay:
>
>Cisco VIC-2FXS Two Port FXS For 2600/3600
>
>This is on the Cisco web site:
>NM-2V1 2-slot voice/fax network module (with footnote 1
>which states: 1 The voice/fax and ATM NMs require a Cisco IOS Plus
>feature set.)
>
>Question:
>
>1. Can I use this module with a standard IP Plus feature set or does it
>have to be enterprise plus? I ask this because I also have an ATM card
>that I tried to get working, but it required the ent. plus.
>
>2. Can I install this card in Slot0 or are these reserved for serial
>only? Below is a 'sh ver' with the available memory.
>
>2620-2#sh ver
>Cisco Internetwork Operating System Software
>IOS (tm) C2600 Software (C2600-IO3-M), Version 12.1(2)T, RELEASE
>SOFTWARE (fc1)
>Copyright (c) 1986-2000 by cisco Systems, Inc.
>Compiled Tue 16-May-00 16:23 by ccai
>Image text-base: 0x80008088, data-base: 0x808D08C8
>
>ROM: System Bootstrap, Version 12.1(3r)T2, RELEASE SOFTWARE (fc1)
>
>2620-2 uptime is 1 hour, 5 minutes
>System returned to ROM by power-on
>System image file is "flash:c2600-io3-mz.121-2.T.bin"
>
>cisco 2620 (MPC860) processor (revision 0x600) with 28672K/4096K bytes
>of memory.
>Processor board ID JAD054606PC (3267703285)
>M860 processor: part number 0, mask 49
>Bridging software.
>X.25 software, Version 3.0.0.
>1 FastEthernet/IEEE 802.3 interface(s)
>32K bytes of non-volatile configuration memory.
>8192K bytes of processor board System flash (Read/Write)
>
>Configuration register is 0x2102
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:25 GMT-3