From: sam (sam@avtechusa.com)
Date: Fri Feb 14 2003 - 11:53:31 GMT-3
Correct me if I'm wrong, but do you need 'ilmi' after the pvc 0/16 ?
RE:(watch wrap)
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/
wan_c/wcdatm.htm#1001470
You must complete the tasks in the following sections to use SVCs:
1.Configuring Communication with the ILMI (Required)
2.Configuring the PVC that Performs SVC Call Setup (Required)
3.Configuring the NSAP Address (Required)
4.Creating an SVC (Required)
.....
1. Configuring Communication with the ILMI
In an SVC environment, you must configure a PVC for communication with
the Integrated Local Management Interface (ILMI) so the router can
receive SNMP traps and new network prefixes. The recommended vpi and vci
values for the ILMI PVC are 0 and 16, respectively. To configure ILMI
communication, use the following command in interface configuration
mode:
Command Purpose
pvc [name] 0/16 ilmi Create an ILMI PVC on an ATM main interface.
Sam Sena
{Wah Lau Eh... I'm in New Jersey...}
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Ong Boon Hui
Sent: Friday, February 14, 2003 9:25 AM
To: ccielab@groupstudy.com
Subject: ATM help pls
Hi,
need help pls, I cannot PING across the following routers with ATM
interfaces
:-
Router 2
interface ATM1/0
ip address 101.1.1.2 255.255.255.0
atm uni-version 3.1
atm esi-address 222222222222.22
atm ilmi-keepalive
atm ilmi-pvc-discovery
pvc 0/5 qsaal
!
pvc 0/16
!
!
svc nsap 39.03488001BC9000010152D800.111111111111.11
protocol ip 101.1.1.1 broadcast
Router 1
interface ATM4/0/0
ip address 101.1.1.1 255.255.255.0
atm esi-address 111111111111.11
atm ilmi-keepalive
atm ilmi-pvc-discovery
pvc 0/5 qsaal
!
pvc 0/16
!
!
svc toR8 nsap 39.03488001BC9000010152D800.222222222222.22
protocol ip 101.1.1.2 broadcast
Getting tired and a little crazy, any help or advice is appreciated.
Debarros
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:23 GMT-3