From: Jennifer Bellucci (Jennifer_bellucci@hotmail.com)
Date: Thu Feb 13 2003 - 06:28:01 GMT-3
Hi....
r1------r2-------r3
All routers are running RIP v2. R1 config is as follows:
router rip
version 2
passive-interface default
no passive-interface Serial5
network 135.25.0.0
no auto-summary
r2 and r3 are running as similar config using net 192.131.1.0. On R1 I add the
following interfaces:
int loop0
ip add 135.25.3.1 255.255.255.0
int loop1
ip add 135.25.36.1 255.255.255.0
int loop2
ip add 135.25.34.1 255.255.255.248
Here's the problem...I remove the network command from r1 and insert the
command 135.25.13.0, but this defaults to 135.25.0.0 in the config and rip.
This also advertises the three loopbacks I have created.
How can I stop the loopbacks being advertised?
Do I have to resort to the distance or distribute-list commands? would off-set
list help?
I was under the impression that RIP v2 allows you to be subnet specific, am I
wrong?
I'd appreciate any help / advice you can offer. I am probably forgetting
something very fundamental, fill me in if you can.
Thanks
Jennifer Bellucci
Jennifer_bellucci@hotmail.com
.
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:21 GMT-3