From: Stong, Ian C [GMG] (Ian.C.Stong@mail.sprint.com)
Date: Wed Feb 12 2003 - 10:59:27 GMT-3
IF you post your router configs and give a bit more information on your ISDN
switch I would be glad to look at it for you.
Ian
www.ccie4u.com
Rack Rentals and Lab Scenarios
-----Original Message-----
From: Yunjie Chen [mailto:ychen@houston.sns.slb.com]
Sent: Tuesday, February 11, 2003 6:10 PM
To: Group Study CCIE LAB
Subject: Question for ISDN
folks:
I was doing a very simple ISDN lab and encoutered the problem which is,
r4#show isdn status
Global ISDN Switchtype = basic-ni
ISDN BRI0/0 interface
dsl 0, interface ISDN Switchtype = basic-ni
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 125, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
TEI = 65, Ces = 2, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
TEI 125, ces = 1, state = 5(init)
spid1 configured, spid1 sent, spid1 valid
Endpoint ID Info: epsf = 0, usid = 1, tid = 1
TEI 65, ces = 2, state = 5(init)
spid2 configured, spid2 sent, spid2 valid
Endpoint ID Info: epsf = 0, usid = 3, tid = 1
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 0 CCBs = 0
The Free Channel Mask: 0x80000003
Number of L2 Discards = 0, L2 Session ID = 3
Total Allocated ISDN CCBs = 0
r5#show isdn stat
Global ISDN Switchtype = basic-ni
ISDN BRI0/0 interface
dsl 0, interface ISDN Switchtype = basic-ni
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 123, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
TEI = 124, Ces = 2, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
TEI 123, ces = 1, state = 5(init)
spid1 configured, spid1 sent, spid1 valid
Endpoint ID Info: epsf = 0, usid = 2, tid = 1
TEI 124, ces = 2, state = 5(init)
spid2 configured, spid2 sent, spid2 valid
Endpoint ID Info: epsf = 0, usid = 4, tid = 1
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 0 CCBs = 0
The Free Channel Mask: 0x80000003
Number of L2 Discards = 0, L2 Session ID = 0
Total Allocated ISDN CCBs = 0
The Layer2 state of both R4 and R5 are always (init) instead of
(established), although it says MULTIPLE_FRAME_ESTABLISHED. Therefore, no
connection can be set up between these two routers. I reset the ISDN
switch, shut down/no shut both routers' BRI interface... none of them
works...
any comments?
Thanks a lot!
.
.
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:19 GMT-3