From: Cassidy D. Smith (csmith@plannetconsulting.com)
Date: Sat Feb 08 2003 - 06:49:11 GMT-3
What you have is one side wanting a DR and the other side not requiring
one. And even though you might get an adjacency to come up by tweaking the
timers (hello's...etc) You must have matching network types otherwise LSA
will not be sent so the database will not synch up properly, so you will
have partial info in your "show ip ospf database" but it will not make it to
your route table. If you are allowed to change your R2 to a sub interface
point-to-multipoint it should work.
Cassidy
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Sage Vadi
Sent: Friday, February 07, 2003 11:41 PM
To: ccielab@groupstudy.com
Subject: OSPF: point-to-point issue (NOT hello mismatch)
All,
In my labs I was testing (OSPF):
R1--point-to-point-------physicalSerial--R2
NB: I cannot use ospf network types which is fine, so
I just did map ip with dlci and neighbor statements.
Adj comes up after hello adjustment.
Problem is I can't see any OSPF routes on R2. This can
work if I change R2 to point-to-point or R1 to
multipoint.
I can't find any obvious doco which states we
would/could have hassles with this?
rgds,
Sage
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:16 GMT-3