From: Adarsh Singh (adarshs@hclinfinet.net)
Date: Tue Jan 07 2003 - 03:15:37 GMT-3
Frame-relay local dlci does the trick , since fr would only know the
destination dlci if frame-relay map ip command is used , which itself
should be mapped as local dlci to the wan ip address, so when you ping the
local ip address it goes to the remote & then returns back.
Hope it helps
Adarsh
----- Original Message -----
From: "Joe" <groupstudy@comcast.net>
To: "'Yong Kim'" <yh.kim@sbcglobal.net>; <ccielab@groupstudy.com>
Sent: Tuesday, January 07, 2003 9:04 AM
Subject: RE: frame-relay question
> I have always used the 'frame-relay local-dlci' command to make this
> work.
>
> FRAME_SWITCH(config-if)#frame-relay local-dlci ?
> <16-1007> Source DLCI number
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> Yong Kim
> Sent: Saturday, January 04, 2003 4:33 PM
> To: ccielab@groupstudy.com
> Subject: frame-relay question
>
>
> Hello,
>
> I figured I would take down the hub router for a while but needed to
> connect the satellite routers directly (using one serial cable).
> However, I can't get it to work!? IOS is 12.1 (auto-sensing LMI).
>
> Is there any way to configure frame-relay between two routers directly
> without a hub router frame-relay switching in the middle or using
> subinterface?
>
>
> R1: DCE side
> interface Serial0
> ip address 192.168.2.1 255.255.255.0
> encapsulation frame-relay
> clockrate 56000
> frame-relay map ip 192.168.2.2 102
>
> R2: DTE side
> interface Serial0
> ip address 192.168.2.2 255.255.255.0
> encapsulation frame-relay
> frame-relay map ip 192.168.2.1 102
>
>
> R1#sh ip interface brief
> Interface IP-Address OK? Method Status Protocol
>
> Serial0 192.168.2.1 YES manual up down
>
>
> I would appreciate it if some one can point out my mistake.
>
>
> Thank you,
>
> Yong Kim
> .
.
This archive was generated by hypermail 2.1.4 : Sat Feb 01 2003 - 07:33:44 GMT-3