From: Joe (groupstudy@comcast.net)
Date: Tue Jan 07 2003 - 00:34:37 GMT-3
I have always used the 'frame-relay local-dlci' command to make this
work.
FRAME_SWITCH(config-if)#frame-relay local-dlci ?
<16-1007> Source DLCI number
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Yong Kim
Sent: Saturday, January 04, 2003 4:33 PM
To: ccielab@groupstudy.com
Subject: frame-relay question
Hello,
I figured I would take down the hub router for a while but needed to
connect the satellite routers directly (using one serial cable).
However, I can't get it to work!? IOS is 12.1 (auto-sensing LMI).
Is there any way to configure frame-relay between two routers directly
without a hub router frame-relay switching in the middle or using
subinterface?
R1: DCE side
interface Serial0
ip address 192.168.2.1 255.255.255.0
encapsulation frame-relay
clockrate 56000
frame-relay map ip 192.168.2.2 102
R2: DTE side
interface Serial0
ip address 192.168.2.2 255.255.255.0
encapsulation frame-relay
frame-relay map ip 192.168.2.1 102
R1#sh ip interface brief
Interface IP-Address OK? Method Status Protocol
Serial0 192.168.2.1 YES manual up down
I would appreciate it if some one can point out my mistake.
Thank you,
Yong Kim
.
This archive was generated by hypermail 2.1.4 : Sat Feb 01 2003 - 07:33:43 GMT-3