From: Tony Schaffran (tschaffran@cconlinelabs.com)
Date: Mon Dec 30 2002 - 16:05:59 GMT-3
To answer your second question, without seeing your entire configs, those
two keywords should not have any affect on your isdn config. The keepalive
0 is just to keep the keepalives from keeping the isdn up if there is no
traffic and the timeout 90 is just the amount of time required to bring up
the isdn in the event of primary link failure.
Like you already stated, Solie has a pretty good description.
Tony Schaffran
Network Analyst
CCNP, CCNA, CCDA,
NNCSS, NNCDS, CNE, MCSE
CCOnlineLabs.com
http://www.cconlinelabs.com
----- Original Message -----
From: "Hunt Lee" <ciscoforme3@yahoo.com.au>
To: <ccielab@groupstudy.com>
Sent: Monday, December 30, 2002 7:38 AM
Subject: ISDN over DLSW
> Hi Group,
>
> I am very very confused about DLSW over ISDN. I tried to simulate the CCO
example
> at:-
>
>
http://www.cisco.com/en/US/customer/tech/tk331/tk336/technologies_tech_note0
9186a0080093ecb.shtml
>
> Firstly, by following the example exactly, I managed to get everything to
work.
> However, according to Solie (p923), & I have also read up lots of
GroupStudy posts,
> in order for ISDN to work with DLSW, one would need these keywords on both
ISDN
> routers:-
>
> keeplive 0 on Local-peer statement
> Timeout 90 on Remote-peer statement
>
> Yet on this CCO e.g., neither of these are used. Why????
>
> Second Question, to make matter worse, after I have tried to put these two
keywords
> on the 2 ISDN routers, RTA don't even dial to RTC anymore...
>
> Any ideas would be greatly appreciated.
>
> On RTA - Tatiasaurus (Loopback int - 1.1.1.1 for simplicity)
>
> dlsw local-peer peer-id 1.1.1.1 keepalive 0
> dlsw remote-peer 0 tcp 2.2.2.2 timeout 90
> dlsw remote-peer 0 tcp 3.3.3.3 backup-peer 2.2.2.2 timeout 90
> dlsw bridge-group 1
>
>
> RTB - Diplodocus (Loopback int - 2.2.2.2)
>
> dlsw local-peer peer-id 2.2.2.2
> dlsw remote-peer 0 tcp 1.1.1.1
> dlsw bridge-group 1
>
> RTC - Tanius (Loopback int - 3.3.3.3)
>
> dlsw local-peer peer-id 3.3.3.3 keepalive 0 promiscuous
> dlsw remote-peer 0 tcp 1.1.1.1 timeout 90
> dlsw bridge-group 1
>
>
> Thanks.
>
> H.
>
> http://movies.yahoo.com.au - Yahoo! Movies
> - What's on at your local cinema?
> .
.
This archive was generated by hypermail 2.1.4 : Fri Jan 17 2003 - 17:21:54 GMT-3