From: Hunt Lee (ciscoforme3@yahoo.com.au)
Date: Mon Dec 30 2002 - 12:38:44 GMT-3
Hi Group,
I am very very confused about DLSW over ISDN. I tried to simulate the CCO example
at:-
http://www.cisco.com/en/US/customer/tech/tk331/tk336/technologies_tech_note09186a0080093ecb.shtml
Firstly, by following the example exactly, I managed to get everything to work.
However, according to Solie (p923), & I have also read up lots of GroupStudy posts,
in order for ISDN to work with DLSW, one would need these keywords on both ISDN
routers:-
keeplive 0 on Local-peer statement
Timeout 90 on Remote-peer statement
Yet on this CCO e.g., neither of these are used. Why????
Second Question, to make matter worse, after I have tried to put these two keywords
on the 2 ISDN routers, RTA don't even dial to RTC anymore...
Any ideas would be greatly appreciated.
On RTA - Tatiasaurus (Loopback int - 1.1.1.1 for simplicity)
dlsw local-peer peer-id 1.1.1.1 keepalive 0
dlsw remote-peer 0 tcp 2.2.2.2 timeout 90
dlsw remote-peer 0 tcp 3.3.3.3 backup-peer 2.2.2.2 timeout 90
dlsw bridge-group 1
RTB - Diplodocus (Loopback int - 2.2.2.2)
dlsw local-peer peer-id 2.2.2.2
dlsw remote-peer 0 tcp 1.1.1.1
dlsw bridge-group 1
RTC - Tanius (Loopback int - 3.3.3.3)
dlsw local-peer peer-id 3.3.3.3 keepalive 0 promiscuous
dlsw remote-peer 0 tcp 1.1.1.1 timeout 90
dlsw bridge-group 1
Thanks.
H.
http://movies.yahoo.com.au - Yahoo! Movies
- What's on at your local cinema?
.
This archive was generated by hypermail 2.1.4 : Fri Jan 17 2003 - 17:21:54 GMT-3