From: Marshall Stacks (catheadcatheadcathead@hotmail.com)
Date: Sun Dec 22 2002 - 09:57:06 GMT-3
I have some known good configs. When I first paste them to the routers, the
ISDN line between R1 & R2 constantly bounces & calls last less than a minute
(idle timeout is default) even though EIGRP hellos are constantantly
traversing the link. If I shut/no shut BRI0/0 on R1 & R2, everything starts
working normally (line stays up forever due to the EIGRP). This is with
12.1(5)T12 on R1 & R2. Anybody care to offer an explanation?
R1 config follows. R2's is similar, as you might expect.
username NORTH password 0 cisco
interface BRI0/0
ip address 130.10.12.1 255.255.255.0
encapsulation ppp
dialer map ip 130.10.12.2 broadcast 8358662
dialer-group 1
isdn switch-type basic-ni
isdn spid1 0835866101 8358661
isdn spid2 0835866301 8358663
ppp authentication chap
ppp chap hostname SOUTH
ppp chap password 7 070C285F4D06
This archive was generated by hypermail 2.1.4 : Fri Jan 17 2003 - 17:21:51 GMT-3