From: Michael Todd (michaeldtodd@comcast.net)
Date: Wed Dec 11 2002 - 11:03:45 GMT-3
Where did you hear that the 3550 doesn't support route-maps? I'm pretty sure
that you can-
http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12112cea/3550scg/s
wiprout.htm#xtocid67
Route-maps are referenced all over this doc. I don't have a 3550 on hand to
double-check, but I'm 99.9% sure you can use route-maps.
Mike
----- Original Message -----
From: "Hung, Sing-Yu" <Sing-Yu.Hung@pccw.com>
To: <ccielab@groupstudy.com>
Sent: Tuesday, December 10, 2002 9:27 PM
Subject: 3550 doesn't support route-map
> Dear,
>
> Just from CISCO that 3550 doesn't support route-map, so is there any
> other method such that we can do the same thing as route-map on 3550?
>
> 10.10.10.0----------(e0)R1(e1)---------20.20.20.0
> (e2)
> |
> |
> |
> |
> 30.30.30.0
>
> A PC on 30.30.30.0 ping to 20.20.20.0, but I have to use route-map
> apply on e2 to route the packet to 10.10.10.0 then 20.20.20.0. No
route-map
> on 3550 so another method?
>
>
> Bradford Hung
>
> Pacific Century CyberWorks
> Tel: 288 33125
> .
.
This archive was generated by hypermail 2.1.4 : Fri Jan 17 2003 - 17:21:45 GMT-3