From: LoizosCisco (david_steven2001@yahoo.com)
Date: Thu Dec 12 2002 - 00:05:01 GMT-3
Hunt,
I always use spid numbers and dialer map in ISDN.
The dialer string is more for dialer profiles.
The first thing I configure when I am working with
ISDN is the spid numbers. Actually here is the
sequence:
1. Configure switch type
2. configure spid numbers while BRI interface is shut
down.
3. NO SHUT the BRI interface
4 Test with "sho isdn status" to make sure your spid
numbers and the connection to the simulator (or tel
company) are good.
5. Then you can configure IP address, encapsulation,
authentication, dialer map, etc.
Loizos
--- Hunt Lee <huntl@webcentral.com.au> wrote:
> Hello,
>
> I am just a starter on learning ISDN (by testing it
> out on ISDN Simulator).
> Can someone please explain to me when I will need to
> use the "isdn spid
> <xxxx>" interface config command?? Is there any
> circumstances that I will
> need to use it?? e.g. when using
>
> - dialer string command
> - dialer map ip command
> - dialer interface
>
> Any help will be greatly appreciated.
>
> Best Regards,
> Hunt Lee
> .
>
This archive was generated by hypermail 2.1.4 : Fri Jan 17 2003 - 17:21:44 GMT-3