From: richard.von.essen@ns.sigma.se
Date: Sun Dec 08 2002 - 13:05:19 GMT-3
Hi!
I have been thinking about a ccie practice question about telnet.
If the ask you to do the following:
7 Configure on router 2 so you can connect to router 4 loopback without
using IP adresses
7 Configure so you will not see R4 ip address in the connection message
7 If the connection fails you should see the following messages
"SECURITY WARNING"
ALL REGULAR TELNET MESSAGES SHOULD NOT BE SEEN WHEN TELNET TO ANOTHER
ROUTER.
I would have suggested this:
ip host r4 "loopback-IP"
service hide-telnet
busy-message r4 # SECURITY WARNING#
But what about the "ALL REGULAR TELNET MESSAGES SHOULD NOT BE SEEN WHEN
TELNET TO ANOTHER ROUTER."??????
Is this the outcome of the previous commands or are they looking for
something else?
I'd appreciate any good suggestions.
Regards
Richard von Essen
.
This archive was generated by hypermail 2.1.4 : Fri Jan 17 2003 - 17:21:40 GMT-3