From: Chris Home (clarson52@comcast.net)
Date: Sat Dec 07 2002 - 10:26:09 GMT-3
If you want to run etherchannel you should remove all the ISL or dot1q stuff
from the server ports on the switch. Unless you have Vlan aware NIC cards
you don't need any of that and they would not be trunk ports.
Just configure etherchannel on the switch then team the nics and plugging
them in. I do not know how intel nics team, but if it is like the compaq
NICS there will be a Nic card team driver that gets installed and allows the
etherchannel option..
----- Original Message -----
From: "Kip Palmer" <RES176RR@verizon.net>
To: <ccielab@groupstudy.com>
Sent: Friday, December 06, 2002 11:15 PM
Subject: Switch Config Proset
> Hello-
>
> Has anyone got the catalyst switch config for this Intel Proset2 dual
> port adapter?
> I'm trying to run it w/ 2 100mg / FastEtherchannel using a port group.
> (ALB FEC)
>
> Intel is about the lamest at documentation.
>
> -----Here's what I've got:
>
> <two server nic ports on switch>
>
> interface FastEthernet0/3
> duplex full
> speed 100
> port group 1 distribution destination
> switchport access vlan 10
> switchport trunk encapsulation dot1q
> switchport mode trunk
> !
> interface FastEthernet0/4
> duplex full
> speed 100
> port group 1 distribution destination
> switchport access vlan 10
> switchport trunk encapsulation dot1q
> switchport mode trunk
> ---
>
> <Cisco Fa1.0 3620 router port on switch>
>
> interface FastEthernet0/2
> duplex full
> speed 100
> switchport access vlan 10
>
> ----
>
>
> Thanks in advance!
>
> Kip Palmer
> .
.
This archive was generated by hypermail 2.1.4 : Fri Jan 17 2003 - 17:21:40 GMT-3