From: Rik Guyler (Rik@Guyler.net)
Date: Thu Dec 05 2002 - 00:04:30 GMT-3
Desmond, I haven't used a routing protocol with the 3550 yet but did you
assign vlan 10 to the switch interface the router plugs into (switchport
access vlan 10)? This should allow the router's interface to communicate
with the vlan 10 interface on the 3550 by putting them into the same
broadcast domain.
Rik
-----Original Message-----
From: Desmond [mailto:cciestudy@sympatico.ca]
Sent: Wednesday, December 04, 2002 3:13 PM
To: ccielab@groupstudy.com
Subject: Question about Cat3550 with latest EMI IOS
I found the Interface vlan x will not pass routing to a router on same VLan.
I need to change the port with "no switch port" and assign IP to it in order
to make it work. I think it worked before with the previous verion. Vlan
interface will not be activated until there is at least one connection for
that vlan.
e.g.
Cat3550
Inter vlan 10
ip add 10.10.10.1
Router Eigrp 1
network 10.0.0.0
2600
Inte fa 0/0
ip add 10.10.10.2
Router Eigrp 1
network 10.0.0.0
Appreicate for anyone provide information !
This archive was generated by hypermail 2.1.4 : Fri Jan 17 2003 - 17:21:38 GMT-3