From: Hinton William Contr AFCA/GCF (William.Hinton@scott.af.mil)
Date: Mon Nov 25 2002 - 17:21:25 GMT-3
Question:
I've got a 5509 w/RSFC, sh int displays the following:
Vlan10 is up, line protocol is up
Hardware is Cat5k RP Virtual Ethernet, address is 0030.f2xx.xxxx
Description: Vlan 10
Internet address is 10.10.10.10/22
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 255/255, load 197/255
Encapsulation ARPA, loopback not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 6 drops; input queue 1/75, 13854 drops
5 minute input rate 21288000 bits/sec, 3142 packets/sec
5 minute output rate 7744000 bits/sec, 2832 packets/sec
3794267750 packets input, 763400563 bytes, 140 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
2125980872 packets output, 1001237829 bytes, 0 underruns(0/0/0)
0 output errors, 3 interface resets
0 output buffer failures, 0 output buffers swapped out
My question is what is the coorelation between the BW, loading and
input/output rate ? I've tried searching Cisco for information on the Cat5k RP
interface but to no avail. The 6509 RP interfaces are normal in that the BW
and loading and input/output rate correlate to each other. Is this a bug?
Thanks.
This archive was generated by hypermail 2.1.4 : Tue Dec 03 2002 - 07:23:10 GMT-3