From: Dotun Oni (dot_oni@hotmail.com)
Date: Tue Nov 19 2002 - 02:04:49 GMT-3
Putti,
If you want to backup the ras voip dial-peer, try this configuration:
dial-peer voice 1 voip
preference 0 ------------> preferred dial-peer
destination-pattern 200
session target ras
dial-peer voice 2 voip ----> backup for dial-peer 1
preference 1
destination-pattern 200
session target ipv4:10.1.1.1
The key here is "backup". In this scenario, the gatekeeper will be tried
first before dial-peer 2 is attempted.
HTH
D
>From: "Jake Jake" <spage@nc.rr.com>
>Reply-To: "Jake Jake" <spage@nc.rr.com>
>To: "Putti Dhamrongsirivadh" <putti@ait.co.th>, <ccielab@groupstudy.com>
>Subject: RE: dial-peer backup
>Date: Mon, 18 Nov 2002 23:20:14 -0500
>
>In theory this should work, its a basic hunt group both with the same
>default preference...having said that I havent specifically tried it.
>
>Jake
>
>-----Original Message-----
>From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
>Putti Dhamrongsirivadh
>Sent: Monday, November 18, 2002 9:25 PM
>To: ccielab@groupstudy.com
>Subject: dial-peer backup
>
>
>Hi all,
>
>I have one voip dial-peer that points session target to ras as command
>"session target ras". If the voice gateway cannot communicate to the
>Gatekeeper, the voice call is unable to set up successfully. So I create
>another voip dial-peer, with the same destination-pattern, that points to
>an exact destination voice gateway as command "session target
>ipv4:10.1.1.1". In order for originating gateway to be able to make a call
>in case of lost gatekeeper connection, can I configure like this to make
>the second voip dial-peer a backup of the ras voip dial-peer?
>
>regards,
>putti
>
>
>config:
>
>dial-peer voice 1 voip
>destination-pattern 200
>session target ras
>dial-peer voice 2 voip ----> backup for dial-peer 1
>destination-pattern 200
>session target ipv4:10.1.1.1
This archive was generated by hypermail 2.1.4 : Tue Dec 03 2002 - 07:23:06 GMT-3