From: MADMAN (dave@interprise.com)
Date: Wed Nov 13 2002 - 17:51:10 GMT-3
Do you mean L2 ports first???
dave
Brian McGahan wrote:
>
> Weidong,
>
> All member ports must be L3 ports first. Try this:
>
> Interface range fa0/1 - 2, po1
> No switchport
>
> HTH
>
> Brian McGahan, CCIE #8593
> Director of Design and Implementation
> brian@cyscoexpert.com
>
> CyscoExpert Corporation
> Internetwork Consulting & Training
> Voice: 847.674.3392
> Fax: 847.674.2625
>
> > -----Original Message-----
> > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
> Of
> > Weidong Xiao
> > Sent: Wednesday, November 13, 2002 1:53 PM
> > To: ccielab@groupstudy.com
> > Subject: 3550 layer 3 etherchannel
> >
> > Hi group,
> >
> > I was running EMI on a 3550 and 'ip routing' enabled, but couldn't set
> up
> > a layer 3 etherchannel.
> > Can somebody tell me what I missed?
> >
> > Thanks in advance,
> >
> > Weidong
> >
> > --------------------------------
> > interface FastEthernet0/1
> > description LINK-TO-RSW1
> > no ip address
> > duplex full
> > speed 100
> > channel-group 1 mode desirable non-silent
> > !
> > interface FastEthernet0/2
> > description LINK-TO-RSW1
> > no ip address
> > duplex full
> > speed 100
> > channel-group 1 mode desirable non-silent
> >
> > and then:
> >
> > SW3(config)#interface Port-channel1
> > SW3(config-if)#no sw
> > SW3(config-if)#no switchport
> > Command rejected: Not a convertable port. <-------WHY?
> > SW3(config-if)#ip address 2.2.2.2 255.0.0.0
> >
> > % IP addresses may not be configured on L2 links.
-- David Madland CCIE# 2016 Sr. Network Engineer Qwest Communications 612-664-3367"You don't make the poor richer by making the rich poorer." --Winston Churchill
This archive was generated by hypermail 2.1.4 : Tue Dec 03 2002 - 07:22:59 GMT-3