From: Andrew Bratchell (a.bratchell@caeuk.com)
Date: Tue Nov 05 2002 - 19:14:55 GMT-3
Tarun,
Yes it can.
It should make no difference whether it a multipoint sub-interface or the actual physical interface.
You will need to use the frame-relay map clns xxx broadcast statement where xxx is your local dlci.
You cannot mix point-to-point and multipoint however.
Andy
-----Original Message-----
From: Tarun Pahuja [mailto:tpahuja@hotmail.com]
Sent: 05 November 2002 21:47
To: ccielab@groupstudy.com
Subject: IS-IS on frame relay
Folks,
Can IS-IS be defined under the main interface. I was
looking at examples on cisco's website and they tend to creat
subinterfaces and then define IS-IS.
------------------------------------------------------------------------
Internet access plans that fit your lifestyle -- join MSN. Click Here
**********************************************************************
Disclaimer
This email is confidential and intended solely for the use of
the individual to whom it is addressed. Any views or opinions
presented are solely those of the author and do not necessarily
represent those of CAE Office Systems. If you are not the
intended recipient, be advised that you have received this
email in error, and that any use, dissemination, forwarding,
printing or copying of this email is strictly prohibited. If you
received this email in error, please contact Lee Gatland on
+44 (0) 1923 477600
**********************************************************************
This archive was generated by hypermail 2.1.4 : Tue Dec 03 2002 - 07:22:53 GMT-3