From: Knut Schubert (ccie@dg4acr.org)
Date: Sun Oct 27 2002 - 18:14:53 GMT-3
Hello Peng,
search for the applique page and look if all the right leds are on, on
the applique back. check if u have a propper cable. which ios do you
run?
cu
Knut
Sunday, October 27, 2002, 9:32:33 PM, you wrote:
PZ> I set up W51 and W41 according to:
PZ> http://www.cisco.com/univercd/cc/td/doc/product/core/cisagspl/agscfig/21594.htm#xtocid174907
PZ> But it didn't work. The same error I got.
PZ> DOes anyone know why?
PZ> --- ccie@dg4acr.org wrote:
>> Hi,
>>
>> there are Jumpers on the Interface Cards you have to
>> set them to DCE
>> Search the Doc CD with the following keywords
>>
>> AGS Hardware Installation
>>
>> If u set them it will work fine
>>
>> cu
>>
>> Knut
>>
>> Peng Zheng <zpnist@yahoo.com> schrieb am 27.10.2002,
>> 19:06:50:
>> > When I set up the clock rate for AGS router ( I
>> want
>> > it to be a frame-relay switch), after I set up:
>> >
>> > no ip address
>> > encapsulation frame-relay
>> > frame-relay lmi-type ansi
>> > frame-relay intf-type dce
>> >
>> > I type :
>> > clock rate 64000, then I got:
>> > Setting clock rate for DTE's is not allowed
>> >
>> > Does anyone know what't the problem?
>> >
>> > Thank you for help.
>> >
>> > Best Wishes,
>> > Peng Zheng
>> >
>> > __________________________________________________
>> > Do you Yahoo!?
>> > Y! Web Hosting - Let the expert host your web site
>> > http://webhosting.yahoo.com/
PZ> __________________________________________________
PZ> Do you Yahoo!?
PZ> Y! Web Hosting - Let the expert host your web site
PZ> http://webhosting.yahoo.com/
-- Best regards, Knut mailto:ccie@dg4acr.org
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:57 GMT-3