From: Brian Dennis (brian@5g.net)
Date: Wed Oct 23 2002 - 16:49:49 GMT-3
Christopher,
A 3550 loaded with the SMI image can do layer 3 protocols after enabling
"ip routing". With the SMI image, RIP and static routes can be used for
routing IP. Also the SMI image can do QOS, rate-limiting, ACLs, etc. It
just can't do more advanced protocols and features like BGP, OSPF,
Multicast, etc. without the EMI image.
Brian Dennis, CCIE #2210 (R&S/ISP Dial)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Christopher M. Heffner
Sent: Tuesday, October 22, 2002 3:27 PM
To: jim.phillipo@guardent.com; troy@onenet.net; kkeen@bigpond.net.au
Cc: ccielab@groupstudy.com
Subject: RE: 3550 BGP Issue
Make sure you have the EMI image on the 3550 switch also and not just
the SMI image on the 3550 which won't do layer 3 protocols.
Hope this helps.
Christopher M. Heffner, CCIE, CCSI
Strategic Network Solutions, Inc.
cheffner@certified-labs.net
-----Original Message-----
From: jim.phillipo@guardent.com [mailto:jim.phillipo@guardent.com]
Sent: Tuesday, October 22, 2002 11:31 AM
To: troy@onenet.net; kkeen@bigpond.net.au
Cc: ccielab@groupstudy.com
Subject: RE: 3550 BGP Issue
I was running a older version of IOS that did not support BGP. I
upgraded
this morning and am up and running.
Thanks to all those who responded.
-----Original Message-----
From: Troy Rader [mailto:troy@onenet.net]
Sent: Monday, October 21, 2002 8:57 PM
To: Kris Keen
Cc: Jim Phillipo; ccielab@groupstudy.com
Subject: Re: 3550 BGP Issue
I am running BGP on a 3550 with EMI on this version of IOS:
c3550-i5q3l2-mz.121-11.EA1.bin.
Do you have 'ip routing' enabled? Just a guess. I haven't tried it.
Troy
Kris Keen wrote:
>I dont believe BGP is a supported protocol just yet, there was
discussion
on
>this earlier, further releases of IOS will bring BGP to be a supported
>protocol, Check CCO
>
>Cheers
>Kris
>----- Original Message -----
>From: <jim.phillipo@guardent.com>
>To: <ccielab@groupstudy.com>
>Sent: Tuesday, October 22, 2002 9:29 AM
>Subject: 3550 BGP Issue
>
>
>
>
>>Whats up with this ?
>>
>>It appears that the command is ok but it will not take it ?
>>
>>cat1#conf t
>>Enter configuration commands, one per line. End with CNTL/Z.
>>cat1(config)#router bgp ?
>> <1-65535> Autonomous system number
>>
>>cat1(config)#router bgp 4799 ?
>> <cr>
>>
>>cat1(config)#router bgp 4799
>>Unknown routing protocol
>>cat1(config)#
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:54 GMT-3