From: Frank Jimenez (franjime@cisco.com)
Date: Tue Oct 22 2002 - 12:57:02 GMT-3
If you're talking about OSPF (are you talking about OSPF?):
You can use this command:
router-id <ip-address>
in the router configuration mode.
To restart OSPF and use the new RID, use 'clear ip ospf'
Frank Jimenez, CCIE #5738
franjime@cisco.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Fan Shan
Sent: Tuesday, October 22, 2002 10:15 AM
To: Ccielab@Groupstudy.Com
Subject: Is there other method except reload router when router id
changed?
If I put a new high loopback interface in a router, and it's part of a
virtual-link, it will change the router id, so I have to reconfigure the
vitual-link with that loopback address, and restart router. But restart
a router will waste some time,I wonder if ther is other methods will
make the router id changed?
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:53 GMT-3