From: Neil Evans (neievans) (neievans@cisco.com)
Date: Mon Oct 21 2002 - 21:40:52 GMT-3
You sure you have the correct version of IOS (EMI)?
! ----------------------
sw1#sho ver
Cisco Internetwork Operating System Software
IOS (tm) C3550 Software (C3550-I5Q3L2-M), Version 12.1(11)EA1, RELEASE
SOFTWARE
(fc1)
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Wed 28-Aug-02 10:03 by antonino
Image text-base: 0x00003000, data-base: 0x0071D658
ROM: Bootstrap program is C3550 boot loader
neievans-sw1 uptime is 4 weeks, 1 day, 4 hours, 10 minutes
System returned to ROM by error - Program Exception (0x0700)!, PC
0x1AE008
System image file is "flash:c3550-i5q3l2-mz.121-11.EA1.bin"
cisco WS-C3550-24 (PowerPC) processor (revision A0) with 65526K/8192K
bytes of memory.
! --- snip ---
sw1#conf t
Enter configuration commands, one per line. End with CNTL/Z.
sw1(config)#router bgp 100
sw1(config-router)#?
Router configuration commands:
address-family Enter Address Family command mode
aggregate-address Configure BGP aggregate entries
auto-summary Enable automatic network number summarization
bgp BGP specific commands
default Set a command to its defaults
default-information Control distribution of default information
default-metric Set metric of redistributed routes
distance Define an administrative distance
distribute-list Filter networks in routing updates
exit Exit from routing protocol configuration mode
help Description of the interactive help system
maximum-paths Forward packets over multiple paths
neighbor Specify a neighbor router
network Specify a network to announce via BGP
no Negate a command or set its defaults
redistribute Redistribute information from another routing
protocol
synchronization Perform IGP synchronization
table-map Map external entry attributes into routing table
timers Adjust routing timers
sw1(config-router)#
-----Original Message-----
From: jim.phillipo@guardent.com [mailto:jim.phillipo@guardent.com]
Sent: Monday, October 21, 2002 4:29 PM
To: ccielab@groupstudy.com
Subject: 3550 BGP Issue
Whats up with this ?
It appears that the command is ok but it will not take it ?
cat1#conf t
Enter configuration commands, one per line. End with CNTL/Z.
cat1(config)#router bgp ?
<1-65535> Autonomous system number
cat1(config)#router bgp 4799 ?
<cr>
cat1(config)#router bgp 4799
Unknown routing protocol
cat1(config)#
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:53 GMT-3