From: STEVER, RANDY (SWBT) (rs4987@sbc.com)
Date: Mon Oct 21 2002 - 18:21:51 GMT-3
Chris,
I don't have a 3550 in my lab, but the last time I had my hands on one, I
tried it both with CRB and IRB and could not get it to work. I did not try
turning off routing, in fact, I made sure that IP routing was enabled (due
to other interfaces on the 3550.) In the CRB scenario I did try moving the
ip addressing to the other sub interface to verify the trunking was good
(let's say from vlan 6 to vlan 5) and I was able to ping the management
interface on the 3550 from the router, but I then lost connectivity to other
routers on vlan 5. Good luck finding an answer, I will be watching this
thread closely.
Randy Stever
CCNP, CCDP
-----Original Message-----
From: Chris Cole [mailto:CCole@EPLUS.com]
Sent: Sunday, October 20, 2002 12:18 PM
To: 'Chris Young'; 'ccielab@groupstudy.com'
Subject: RE: 3550 BVI/router on a stick problem any solutions
Chris, I have a 3550 isl trunk into a 2600. the 3550 has a management Vlan 5
that need to be bridged over to vlan 6 in the same subnet. On the 2600 I
have irb bridging, sub interfaces, bridge-group **, int BVI**. It does work,
but I can't ping the management interface. What I mean by work is : if I set
another interface on the 3550 to say vlan 5 on the same subnet as vlan 6,
the host to host can ping. But not the management interface. I took the same
config over to a 2924 and bing-go it works. So it's some thing with the
management Vlan on the 3550. I also made a loopback put it in vlan 5 same
subnet and no go, not pinging.. My post was in reference to all the other
posts on the same subject. I thought it a waste of time to restate what had
been stated many times before. I was just wondering if any body came up with
a answer yet. From the last post it look like you had to remove a line about
native vlan but my configs do not have such a line.
isl trunk
3550vlan5-----| irb int bvi **
|---------2600
hostvlan6-----|
-----Original Message-----
From: Chris Young [mailto:csyoung@speakeasy.net]
Sent: Friday, October 18, 2002 6:59 PM
To: Chris Cole; ccielab@groupstudy.com
Subject: RE: 3550 BVI/router on a stick problem any solutions
Chris,
What problem are you referring to specifically? I must have missed that
message.
Chris
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Chris Cole
Sent: Friday, October 18, 2002 5:13 PM
To: ccielab@groupstudy.com
Subject: 3550 BVI/router on a stick problem any solutions
I have this problem also. I have look through all the archives to make
sense
of this. All I've come up with is it shows up as Incomplete in the "sh
arp."
Chris
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:53 GMT-3