From: Prashanth (prashanthcm@yahoo.com)
Date: Tue Oct 15 2002 - 03:02:16 GMT-3
T (terminator) has a default inter-digit timeout value
of 10sec... you can change this value under the
voice-port to a lower value or hit the # sign after
dialling
prashanth
--- Jay <ccienxtyear@hotmail.com> wrote:
> Hi,
>
> I have setup voip between 2 routers. Heres config
> for one of them (voice
> specific config)
>
> dial-peer voice 1 pots
> destination-pattern 5555000
> port 3/1/0
> !
> dial-peer voice 100 voip
> destination-pattern T
> session target ipv4:160.100.2.254
> req-qos guaranteed-delay
> ip precedence 5
> !
> num-exp 2400 5552400
> num-exp 4000 5554000
>
>
> So when I dial 2400 (or 5552400) and hit #, the
> other phone starts ringing
> right away. If I just dial 2400 (or 5552400) without
> hitting #, it takes about
> 10 seconds before that phone rings. Is there a way
> to configure it to send the
> digits right away instead of the 10 sec delay. I do
> not want to configure wild
> cards such as using the dots.
>
> thanks,
> Jay
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:47 GMT-3