From: Donny MATEO (donny.mateo@sg.ca-indosuez.com)
Date: Wed Oct 09 2002 - 03:56:24 GMT-3
don't think clock rate has anything to do with OSPF as a protocol. But clockrate determined your
physical port speed for transmitting data and such so called physical port speed.
Bandwidth however do effect cost calculation on OSPF. You should set the bandwith in referance to
the clock rate set for the interface.
Donny
"Nathan Chessin"
<nchessin@cisco.c To: "'groupstudy'" <ccielab@groupstudy.com>
om> cc:
Sent by: Subject: OSPF Bandwidth/Clock Rate/Cost Commands
nobody@groupstudy
.com
09-10-2002 14:23
Please respond to
"Nathan Chessin"
Does clock rate have anything to do with cost of OSPF or frame-relay traffic
shaping? Or is this only affected by bandwidth command?
Thanks,
Nate
This message is for information purposes only and its content
should not be construed as an offer, or solicitation of an offer,
to buy or sell any banking or financial instruments or services
and no representation or warranty is given in respect of its
accuracy, completeness or fairness. The material is subject
to change without notice. You should take your own independent
tax, legal and other professional advice in respect of the content
of this message. This message may contain confidential or
legally privileged material and may not be copied, redistributed
or published (in whole or in part) without our prior written consent.
This email may have been intercepted, partially destroyed,
arrive late, incomplete or contain viruses and no liability is
accepted by any member of the Credit Agricole Indosuez group
as a result. If you are not the intended recipient of this message,
please immediately notify the sender and delete this message
from your computer.
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:43 GMT-3