From: Olive, Darren (Darren.Olive@globalcrossing.com)
Date: Wed Sep 04 2002 - 06:37:49 GMT-3
We use something similar to the config shown below. Apologies in advance for
any typo's.
username r1 password xxxxx
!
interface bri0/0
no ip address
encapsulation ppp
dialer pool-member 1
isdn switch-type xxxxx
ppp authentication chap
ppp multilink
!
interface bri0/1
no ip address
encapsulation ppp
dialer pool-member 1
isdn switch-type xxxxx
ppp authentication chap
ppp multilink
!
interface d0
ip address x.x.x.x x.x.x.x
bandwidth 256
encapsulation ppp
dialer remote-name r1
dialer string xxxxxxxxx
dialer load-threshold 128 either (multilink is initiated when bandwidth
exceeds 50% in either direction)
dialer pool 1
dialer-group 1
ppp authentication chap
ppp multilink
!
dialer-list 1 protocol ip permit
-----Original Message-----
From: bravo [mailto:bravojun@hanmail.net]
Sent: 04 September 2002 10:17
To: ccielab@groupstudy.com
Subject: [OT]Is it possible to load balancing two bri port with
multilink ppp?
Hello. guys
Our one site has 3600 with one pri and the other site has two bri line.
So is it possible to use both two bri line?
The multilink ppp can be used in this situation?
Multilink ppp can load balancing two isdn bri line?
I found the document in cisco web site that configured both two bri line.
http://www.cisco.com/warp/public/471/bri-mppp.shtml
It can also be applied when use one pri and two bri?
Thanks in advance.
[TABLE NOT SHOWN][IMAGE]
[TABLE NOT SHOWN][TABLE NOT SHOWN]
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:43:43 GMT-3