From: Brian Dennis (brian@xxxxxx)
Date: Sat Aug 24 2002 - 21:33:56 GMT-3
Joe,
You'll get this error when you try to put in a neighbor statement to an
IP address that is assigned to the local router.
R11#sho ip int bri e0
Interface IP-Address OK? Method Status
Protocol
Ethernet0 10.1.1.1 YES manual up
up
R11#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R11(config)#router bgp 10
R11(config-router)#neighbor 10.1.1.1 remote-as 10
% Cannot configure the local system as neighbor
R11(config-router)#neighbor 10.1.1.2 remote-as 10
R11(config-router)#
Brian Dennis, CCIE #2210 (R&S/ISP Dial)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Joseph Rinehart
Sent: Saturday, August 24, 2002 4:36 PM
To: ccielab@groupstudy.com
Subject: BGP over GRE Tunnel
Hi All. Weird problem I can't seem to figure out.
I am trying to set up a Lab scenario (specifically Lab 51 in the Cisco
CCIE
Lab Study Guide by Hutnik and Satterlee) and keep running into a
problem. The
way my lab is cabled (I work on it remotely) I am missing an extra
serial
interface needed for a BGP Confederations exercise. I figured it would
be
easy to just substitute a GRE Tunnel interface for the serial line (I
have
been able to do this for IGP setups with ease). I am using a /30 just
as you
would any serial link but when I try to configure the neighbor statement
I get
the error "cannot configure local system as neighbor." I have checked
teh
addressing and tried to use the tunnel though both Ethernet and Serial
interfaces with the same result.
Any insight on this?
Joe
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:36 GMT-3