From: Nick Shah (nshah@xxxxxxxxxxxxxx)
Date: Fri Aug 23 2002 - 05:11:33 GMT-3
you are correct,
Solie seems to be full of errors
rgds
----- Original Message -----
From: Hotmail <ccie_yong@hotmail.com>
To: Nick Shah <nshah@connect.com.au>; <ccielab@groupstudy.com>
Sent: Friday, August 23, 2002 6:05 PM
Subject: Re: Solie' s page 438
> Hi,
>
> The 1st query was from CCIE practical studies Vol I by Karl Solie, on page
> 438, it configure the "frame class voice" on the serial subinterface, but
I
> thought u need additional command (frame traffic-shaping) on the serial
main
> interface to make it work.
>
> regards
> Yong
>
> ----- Original Message -----
> From: "Nick Shah" <nshah@connect.com.au>
> To: "Hotmail" <ccie_yong@hotmail.com>; <ccielab@groupstudy.com>
> Sent: Friday, August 23, 2002 3:36 PM
> Subject: Re: Solie' s page 438
>
>
> > I am not sure what you mean here, I am not having Solie atm. So pl. be
> > specific about the first query.
> >
> > Regarding the second query.
> >
> > IP RTP PRIORITY specifies ports to be prioritized, and guaranteed
> bandwidth
> > to be assigned, can be used with voice & anythign else as well.
> > IP RTP Header - compression, compresses data.
> >
> > They usually go hand in hand, however there is a catch, you need to
> specify
> > "bandwidth" after compression (if using RTP header compression along
with
> > priority)
> >
> > You can also use ip rtp priority on its own (without rtp
compression)
> >
> > If using on non-frame relay interfaces, use IP RTP PRIORITY, and if
using
> on
> > frame-relay, ideally, specify a map-class and specify frame-relay ip rtp
> > priority.
> >
> > rgds
> > Nick
> > ----- Original Message -----
> > From: Hotmail <ccie_yong@hotmail.com>
> > To: <ccielab@groupstudy.com>
> > Sent: Friday, August 23, 2002 4:54 PM
> > Subject: Solie' s page 438
> >
> >
> > > Hi, on Solie's pg 438, Thought that you need an additional command of
> > > "frame-relay traffic-shaping" in interface s2/0 if configure
> "frame-relay
> > > class voice" in interface s2/0.1 point-to-pt and secondly is it always
> > that
> > > when there is "frame-relay ip rtp priority ...." command in map-class
> > mode, it
> > > will have to work in conjunction with "frame-relay ip rtp
> > header-compression"
> > > command in interface mode ?
> > >
> > > Thanks & Regards
> > > Yong
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:35 GMT-3