Flapping token-ring interface

From: Krucker, Louis (louis.krucker@xxxxxxxxxxx)
Date: Thu Aug 22 2002 - 07:20:55 GMT-3

• Next message: Raj: "DLSW problem - direct vs dlswlite"
• Previous message: Fong, Eddy: "RE: 1st attmpt fail"
• Next in thread: Luis Miguel Gil: "RE: Flapping token-ring interface"
• Maybe reply: Luis Miguel Gil: "RE: Flapping token-ring interface"
• Maybe reply: Pettice, Neil: "RE: Flapping token-ring interface"
• Maybe reply: Fred Ingham: "Re: Flapping token-ring interface"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Hi Group

I faced an interesting problem today. I have a flapping token ring interface
which is connected to a cat3920.

The cat port which this to0/0 is connected is configred for Ring 3 but
because
i dont have dslw configured on this to0/0 , no source-bridge [Ring#] is
configured.
My toughts.... because no ring is configured on to0/0, the interface flaps,
but i am
not sure.....

Any comments apriciated.....

Regards
Louis

• Next message: Raj: "DLSW problem - direct vs dlswlite"
• Previous message: Fong, Eddy: "RE: 1st attmpt fail"
• Next in thread: Luis Miguel Gil: "RE: Flapping token-ring interface"
• Maybe reply: Luis Miguel Gil: "RE: Flapping token-ring interface"
• Maybe reply: Pettice, Neil: "RE: Flapping token-ring interface"
• Maybe reply: Fred Ingham: "Re: Flapping token-ring interface"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:33 GMT-3