From: steven.j.nelson@xxxxxx
Date: Wed Aug 07 2002 - 13:00:22 GMT-3
Group,
I have seen many configs on this subject and most of them seem to state that
the border should run promiscuous, while the group members or "spokes"
should have a configured peer to the border.
I have also seen that if there is more than one border then the two borders
should also peer to each other.
So...
I was wondering can I configure it in reverse, i.e have promiscuous on the
members or "Spokes" and some configured peers on the border router ?
I have been trying out different scenarios all day and just can't get it to
work, the members see the correct entries in the reachability cache, the
border sees all but I can't get a peer on demand up between to member peers.
Any help ???
Thanks alot
Steve
Steve Nelson
Customer Engineer
BT Ignite- National Solutions
T: +44 (0)1422 338881 M: +44 (0)7811 944172
e-mail: steven.j.nelson@bt.com
pp HW A170, PO Box 200(HOM-NZ), London, N18 1ZF
> British Telecommunications plc
> Registered office: 81 Newgate Street London EC1A 7AJ
> Registered in England no. 1800000.
> This electronic message contains information from British
Telecommunications plc which may be privileged or confidential. The
information is intended to be for the use of the individual(s) or entity
named above. If you are not the intended recipient be aware that any
disclosure, copying, distribution or use of the contents of this information
is prohibited. If you have received this electronic message in error, please
notify us by telephone or email (to the numbers or address above)
immediately.
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:18 GMT-3