From: Christopher M. Heffner (cheffner@xxxxxxxxxxxxxxxxxx)
Date: Tue Aug 06 2002 - 15:12:39 GMT-3
FYI - for solution 3 listed below you must list the password as the last
part of the username command. It cannot be listed as shown below.
Must be - Username testuser priv 15 password cisco
Chris Heffner
CCSI, CCIE
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Krucker, Louis
Sent: Tuesday, August 06, 2002 11:59 AM
To: 'Zhang, Ou (David) '; ''ccielab@groupstudy.com' '
Subject: RE: CCIE Practical Studies
Hello
p. 1167
9.2 Configure R3 so that workstations in Vlan 30 can dynamically
locate
their default gateway. They are not using DHCP. (R3 hosts Vlan 30.)
- configure ip irdp on the router
p. 1175
2.2 Configure the Catalyst so that if the backplane of the switch
gets
overloaded, the ports in VLAN 30 get serviced before those in VLAN 50.
(The
switch hosts these two vlans in question.)
- configure "set port level" on the cat5k
p. 1177
11.1 Configure R1 so that when the user unnamed logs into the router,
that user immediately is put in enable mode.
configure " username unamed password blahblah privilid.. level 15"
By the way i think you can found the solutions on www.ciscopress.com
under
the dl section.
cheers
Louis
-----Original Message-----
From: Zhang, Ou (David)
To: 'ccielab@groupstudy.com'
Sent: 06.08.2002 16:35
Subject: CCIE Practical Studies
Hello,
I'm totally stuck with the following questions from the CCIE Practical
Studies vol. 1. I'd appreciate any answers, hints or suggestions.
Thanks.
p. 1167
9.2 Configure R3 so that workstations in Vlan 30 can dynamically
locate
their default gateway. They are not using DHCP. (R3 hosts Vlan 30.)
p. 1175
2.2 Configure the Catalyst so that if the backplane of the switch
gets
overloaded, the ports in VLAN 30 get serviced before those in VLAN 50.
(The
switch hosts these two vlans in question.)
p. 1177
11.1 Configure R1 so that when the user unnamed logs into the router,
that user immediately is put in enable mode.
-David
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:17 GMT-3