From: Prakash H Somani (pdsccie@xxxxxxxxxxxxxx)
Date: Wed Jul 31 2002 - 12:02:13 GMT-3
I can think of following solution...
USe dialer interface for two site connectivity and when defining
dialer pool use following
R3(config-if)#dialer pool-membe
R3(config-if)#dialer pool-member 1 ?
max-link Maximum number of B channels for pool
min-link Minimum number of B channels for pool
priority Priority of interface in pool
Use MAX-Link and Min-Link to define how may B-Channel u want to
trigger from PRI...Should this solve your problem ?
regards....Prakash
On Tue, 30 Jul 2002 Ccieyet2b@aol.com wrote :
>Hi all,
>
>If an isdn connection is always between a BRI and a PRI, and ppp
>multilink is
>configed on both ends, the most bandwidth that can be used is
>128k or 2
>b-channels.
>
>But, what if it's possible for the connection to be between to
>PRI's. Is
>there a way to limit how many b-channels will be brought up?
>
>For example, let's say that ISDN is provisioned to back up F/R
>cir's and if
>the cir is 128k or less, a BRI is provisioned and if the cir is >
>128k, a PRI
>is provisioned. And, the objective is to provide the same
>bandwidth with ISDN
>as is used with F/R. So, where the cir = 256k, you want isdn to
>use up to
>but no more than 4 b-channels. How can this be done?
>
>On a related topic, is there a way to configure isdn so that it
>can be used
>to augment Frame-Relay bandwidth? If so, how would that be
>done?
>
>Thanks, Jim
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:36:50 GMT-3