From: Jake (jakeczyz@xxxxxxxxx)
Date: Sat Jul 27 2002 - 18:53:22 GMT-3
Ajit,
If you're sending more than one VLAN down any link (even Gigabit) you'll nee
d to make
it a trunk (either dot1q or isl - depending on what your platform supports - al
though it
looks like cisco is moving toward dot1q and away from its proprietary isl). So,
set the
GIG interface on the cat to trunk the vlans you need to send to the 7200. Simil
arly, the
4 ports going to the 3640 will each need to have trunking enbled with the prope
r vlans
and the right encapsulation (isl or dot1q, usually).
The 5000 series command is:
set trunk <x/x> ON <vlan #'s> <isl, dot1q, etc.>
More detail here, please watch the wrap:
<http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_5_5/cmd_ref/se
t_v.htm#24616>
Hope this helps,
Jake
9102
--- Ajit Das <ajidas@cisco.com> wrote:
> Hi All,
>
> I would like to configure vlan between 3600 and 7200 router as shown
> below.
>
> 3640-----catalyst5k----7200
>
> There are 4 FE cards which connects to 4 FE ports on catalyst5k.
> The link between catalyst and 7200 is GigE.
>
> The requirement is to configure 5 vlans in each FE on 3640 and they will
> map 1-to-1 at GigE on 7200.
> I am able to configure 5 vlans in each FE port on 3640. and 20 vlans on
> 7200. Do I have to configure trunk between 7200 and catalyst. Can some
> one shed light on config at catalyst switch.
>
> Thanks in advance.
>
> Thanks
> AD
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:36:46 GMT-3