RE: vlan config

From: Joe A (GroupStudy@xxxxxxxxxxx)
Date: Wed Jul 24 2002 - 00:37:02 GMT-3

• Next message: Joe A: "RE: OSPF keeps bringing up DDR across asyn line"
• Previous message: Isianto Istiadi: "bridge number in the trbrf"
• Maybe in reply to: Ajit Das: "vlan config"
• Next in thread: Jake: "Re: vlan config"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
If I am reading this correct, you'll have to trunk everywhere. Without a
trunk, you can only have one vlan tag in the frames going across the link,
i.e. only one vlan per link. I suppose you could play around with secondary
addresses, but that's gonna get ugly.

- Joe

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Ajit Das
Sent: Tuesday, July 23, 2002 1:06 PM
To: ccielab@groupstudy.com
Subject: vlan config

Hi All,

I would like to configure vlan between 3600 and 7200 router as shown
below.

3640-----catalyst5k----7200

There are 4 FE cards which connects to 4 FE ports on catalyst5k.
The link between catalyst and 7200 is GigE.

The requirement is to configure 5 vlans in each FE on 3640 and they will
map 1-to-1 at GigE on 7200.
I am able to configure 5 vlans in each FE port on 3640. and 20 vlans on
7200. Do I have to configure trunk between 7200 and catalyst. Can some
one shed light on config at catalyst switch.

Thanks in advance.

Thanks
AD

• Next message: Joe A: "RE: OSPF keeps bringing up DDR across asyn line"
• Previous message: Isianto Istiadi: "bridge number in the trbrf"
• Maybe in reply to: Ajit Das: "vlan config"
• Next in thread: Jake: "Re: vlan config"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:36:41 GMT-3