From: Przemyslaw Karwasiecki (karwas@xxxxxxxxxxx)
Date: Sat Jul 20 2002 - 20:01:53 GMT-3
If AGS+ works the same way as other routers, type of serial
interface (DTE vs DCE) is determined by type of serial cable
(in AGS maybe type of applique).
On the other hand, to successfully configure FR switching,
interfaces on FR switch don't necessarily need to be DCE.
What is important is, that interfaces will be configured
as "frame-rely intf-type dce" and that you will enable
"frame-relay switching" in global config.
Please see snippet from my config as an example:
frame-relay switching
!
interface Serial0
no ip address
encapsulation frame-relay
frame-relay lmi-type ansi
frame-relay intf-type dce
frame-relay route 201 interface Serial1 102
!
Hope this helps,
Przemek
On Sat, 2002-07-20 at 18:26, Ccieyet2b@aol.com wrote:
> Hi,
>
> I'm trying to configure an AGS+ as a frame relay switch without much success.
> It's running version 9.1 and I can't figure out how to change the serial
> interfaces from DTE to DCE. Putting in the clockrate command doesn't work.
> I get a message that "setting clockrate on a DTE" isn't allowed. And, the
> documentation for version 9.1 doesn't say anything about about this or
> configuring this router as a frame relay switch.
>
> Can anyone help me out?
>
> Thanks in advanced.
>
> Jim
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:36:38 GMT-3