From: Michael Snyder (msnyder@xxxxxxx)
Date: Sun Jul 14 2002 - 01:53:39 GMT-3
Redistribute the connected network into one or both of the protocols.
In other words, if a routing protocol is missing a needed network, add
it with the redistribute connected command.
Another trick is to LOWER the distance of the rip routes so you can see
them in the routing table. Because you can't redistribute rip routes
not in the routing table. If you do lower the distance of rip make sure
you filter the unwanted routes!
redistribute connected metric 20 subnets route-map connected
route-map connected p 10
match interface X
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Benny Ma
Sent: Saturday, July 13, 2002 10:12 PM
To: ccielab@groupstudy.com
Subject: Redistribution Question
Hi all,
Following is my lab topology.
R1--(RIP)--R2--(OSPF)--R3
I'm doing a reredistribution from RIP to OSPF. The problem is all the
other route entry is OK except the direct connected route between R1 and
R2.
I have no idea about it. Thanks in advance.
Cooz
---------------------------------
Do You Yahoo!?
RxPP>^M7>[;aVPT- 4s@KLT!.=p!/K-=+P&0A?
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:36:29 GMT-3