From: Tom Young (gitsyoung@xxxxxxxxxxx)
Date: Thu Jun 27 2002 - 01:27:44 GMT-3
Thanks for you reply, would you plz let me check some
points?
1, I should config a modem to connect my aux port.
2, The cable between router and medom is a crossover
cable.
3, I should set a password for dail-in authentication. If
so, how about the user ID?
Thanks alot
Tom
--- Jay Hennigan <jay@west.net> $B$+$i$N%a%C%;!<%8!'(B
> On Thu, 27 Jun 2002, Tom Young wrote:
>
> > If I want to set a dial in configuration, that
> dial into
> > my router for remote maintance. Would you plz
> check the
> > manual for me?
> >
> > 1,Connect a dialog tele line into my router.
> >
> > 2,Only config the data blow
> >
> > autoband
> > modem InOut
> > transport input all
> > flowcontrol hard
> > stopbit 1
> > login
>
> You would do this in the "line aux 0" section.
>
> You should also configure a password on the line in
> the same section.
> While in the config-line section add "password
> cisco" which would set
> the password to "cisco". You might want something
> less obvious.
>
> Also set an enable secret.
>
> You'll also need to configure the modem for
> auto-answer and connect it to
> the Aux port with the appropriate rollover cable and
> hood.
>
> > 3,To dial the tele line's Number for coming into
> the
> > router from remote.
>
> Yep.
>
> --
> Jay Hennigan - CCIE #7880 - Network Administration -
> jay@west.net
> NetLojix Communications, Inc. -
> http://www.netlojix.com/
> WestNet: Connecting you to the planet. 805
> 884-6323
>
This archive was generated by hypermail 2.1.4 : Tue Jul 02 2002 - 08:12:42 GMT-3