From: Brian Dennis (brian@xxxxxx)
Date: Fri Jun 21 2002 - 14:00:21 GMT-3
Try this (from CCO):
<CCO>
Connect to the router with the following terminal settings:
1200 baud rate
No parity
8 data bits
1 stop bit
No flow control
You no longer see any output on your screen. This is normal.
Power cycle (switch off and then on) the router and press the spacebar
for 10-15 seconds. This generates a signal similar to the break
sequence.
Disconnect your terminal and reconnect with a 9600 baud rate. You should
now be in ROM Monitor mode.
</CCO>
Also what is the exact config register?
Brian Dennis, CCIE #2210 (R&S/ISP Dial)
bdennis@5g.net
5G Networks, Inc.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Casey, Paul (6822)
Sent: Friday, June 21, 2002 9:22 AM
To: CCIE-Groupstudy
Subject: Help required ASAP...
Here my serious problem
I have a router and I dont know the enable password for it, 12-14 months
old
and no one can remember the password.
Thats not the worst
I can get into user mode and when I type show version the confreg
register
is set to something like 0x210004 ... (seemed a bit funny)
Now when the router boots and I connect to the console port you cant see
anything happening on the console port, therefore I cant get into romon
mode Pressing keys has not effect, You just cant see anything or do
anything
This confreg-reg setting must have done something serious.
However, after several minutes "press any key to continue" appears on
hyper
terminal screen and I am back in user mode again.
I need to get access to this router ASAP and get access to romon fix the
password problem.
it is a 2600 series router .....
Also when I check the interfaces for user mode, they are all
administratively shut down... so thats no help...
I seemed to be locked out of the router, except for user mode which
seems to
be good for nothing.
A bit of a catch 22 situation.
Any help appreciated.,..
************************************************************************
****************
This E-mail is from O2. The E-mail and any files
transmitted with it are confidential and may also be privileged and
intended
solely for the use of the individual or entity to whom they are
addressed.
Any unauthorised direct or indirect dissemination, distribution or
copying
of this message and any attachments is strictly prohibited. If you have
received the E-mail in error please notify postmaster@O2.com or
telephone ++ 353 1 6095000.
************************************************************************
*****************
This archive was generated by hypermail 2.1.4 : Tue Jul 02 2002 - 08:12:39 GMT-3